Bending Drain – Cement and Concrete shrinkage and expansion tester
 
Bending Drain – Cement and Concrete shrinkage and expansion tester

Bending Drain – Cement and Concrete shrinkage and expansion tester

With the Bending Drain you measure the shrinkage and bending of building materials. Also you may simulate with a built in electrical heating a real world floor heating.

High precision measurement are guaranteed, by two static abutments and a massive u-shaped steel baseplate. A neoprene foil between the form work and the material avoids friction and blocking of material, also when expanding materials are used. The form work is static independent from the mortar beam which is supported by two well defined points.

The Bending Drain has an Intra- / Internet connection and an integrated data logger. No special PC is required during the measurement. The instrument is fully controlled by your network browser software, like the Internet Explorer or similar software. All data are stored inside on non volatile memory for weeks or months. By one mouse click you can load the data directly into your Excel worksheet over a network. You may also transfer you data with a removable Compact Flash card.

You may integrate several Bending Drains into your network

You may integrate several Bending Drains into your network, but each of it is working indepently. Two high resolution LVDTs with a stroke of 5mm and a resolution of 0.3µm are delivering high reliable results.

Two RTDs are measuring the temperature on the bottom of the form work as well in the air or in the specimen. An additionally moisture/temperature sensor may be connected.

For the floor heating you can program a temperature profile over time.

For example rising the temperature after 6 days from 20°C to 60°C holding it for 3 days, and coming down to 20°C again.

Measurement Example

Below you see a typical data plot. The x-Axis shows the time in days, the y-axis temperature in °C and length change in microns. After 4 and half day the floor heating was activated. The green line shows the temperature at the bottom of the specimen, the blue line is the temperature in the core of the specimen. The red line shows the bending, the black one the length change.

Measurement Example
Technical Data
Measurement Range in Both Directions 5 mm
Specimen Length 1000 mm
Resolution
0,3 µm
Accuracy better
±4 µm
Max. Temperature 70 °C
Heating >120 W bei 20 °C
Weight
36 kg
 

For further information or to place an order for the Bending Drain – Cement and Concrete shrinkage and expansion tester CLICK HERE, call us Toll-Free at: 1.877.884.TEST, or click on the "HOW TO ORDER" Button