Cord Anchorage Tester

Request A Quote
Product Categories
Standards

Cord Anchorage Tester - QualiCAT™

QualiCAT™ cord anchorage tester applies controlled pull forces and torque to a supply cord where it enters an appliance, verifying that the cord anchorage holds the cable and relieves the internal terminals of strain. Compliance laboratories and appliance manufacturers use it to confirm that a cord grip design survives the loads a product meets in service. The instrument runs both halves of the assessment, tension and twist, in one automated sequence. An operator sets the parameters once and the controller handles the rest.

Cord anchorage failures put stress directly onto conductor terminations inside the housing. A cable that creeps through its clamp transfers pulling and twisting loads to the terminals. Loose connections and abraded conductor insulation at the cord entry follow from there. The QualiCAT™ measures how far a marked point on the cord moves after the full test sequence, converting anchorage performance into a single measured displacement value.

The QualiCAT™ is available in a single-station or six-station configuration, so a laboratory can match capacity to sample throughput. PLC control with a touch interface drives the pull cycle and the torque dwell, and the tension count and torque duration both adjust to suit different appliance categories. A graduated weight set covers pull forces of 30 N, 60 N, and 100 N along with torque values of 0.1 Nm, 0.25 Nm, and 0.35 Nm.

Request
Quotation