Theory and Method
Distributed pressure loads a sheet very differently from a point contact. A plunger pressed into a geomembrane concentrates stress at the contact edge, and failure starts there almost regardless of how strong the rest of the specimen is. Uniform pressure across a circular span does the opposite: the material stretches biaxially, every direction in the plane carries load at once, and rupture happens when the weakest region of the whole exposed area gives way. Burst strength therefore reports something closer to the material's inherent biaxial capacity, which is why specifications ask for it alongside puncture and tensile figures rather than in place of them.
The diaphragm arrangement is what makes the loading clean. Fluid does not touch the specimen. It pumps into a chamber beneath an elastomeric diaphragm, and that diaphragm expands upward through the orifice, pressing against the underside of the clamped material and carrying it into a dome. Load transfers through the diaphragm as uniform pressure with no jetting, no local contact, and no fluid absorption into the specimen. Pressure is read continuously and the peak value at rupture is the result.
Rate control matters more than it first appears. Polymers are viscoelastic, so they respond stiffer when loaded quickly and softer when loaded slowly, and a specimen pressurized in ten seconds will report a higher burst pressure than the same material pressurized over a minute. Fixing the fluid inflow at 100 ml/min removes that variable, so results compare between operators, between shifts, and between laboratories. Clamping geometry does similar work: the Ø55 mm specimen over a Ø30.5 mm orifice leaves roughly 12 mm of clamped width all round, enough to hold the specimen without slipping while the dome forms and pressure climbs toward the top of the range.