Geosynthetic Sample Cutter - QualiGTX™ GSC
QualiGTX™ GSC Geosynthetic Sample Cutter produces clean, dimensionally accurate test specimens from geotextiles, geomembranes, composite liners, geogrids, and drainage products in a single hydraulic stroke. A motor-driven pump develops up to 20 kN of cutting force through a piston with 80 mm of travel, which shears through thick needle-punched nonwovens and reinforced sheet materials that resist hand cutting. The instrument ships with a die cutting a 100 cm² sample, the area laboratories use for mass per unit area determination.
Specimen preparation quality sets the ceiling on the accuracy of every test that follows. Scissors and templates leave frayed edges, stretched corners, and area errors that carry straight into tensile, thickness, and mass results. The GSC removes that variability by cutting to a fixed die profile under repeatable force, so every specimen from a roll matches every other one. Operators load the material onto the 320 × 320 mm worktable, position the die, and run the stroke.
Geosynthetics manufacturers, construction quality assurance laboratories, and certification bodies use the GSC as the front end of their testing workflow. The unit weighs 80 kg and stands 1200 mm tall in a 600 × 500 mm footprint, so it occupies a corner of the sample preparation area rather than a full bench. Simple electro-hydraulic operation keeps training short for laboratories where several technicians share the equipment.