Geosynthetic Hydrostatic Pressure Testers
Geosynthetic Hydrostatic Pressure Testers | Impermeability and Permeability Testing to 2.5 MPa
Geosynthetic hydrostatic pressure testers measure how much water pressure a geomembrane or barrier liner holds before it starts to leak. Liner producers, materials laboratories, and civil engineering test houses use them to qualify barrier materials for landfills, canals, reservoirs, and tailings ponds. Every model in this range clamps a ø200 mm specimen and applies water pressure from zero to 2.5 MPa.
Several models also determine permeability coefficient, the steady-state flow figure that seepage design calculations depend on, using the constant-head approach described in EN 14150. The range runs from an entry-level bench through touchscreen units with temperature control up to a three-station system for parallel testing.
Why Choose Qualitest for Your Geosynthetic Hydrostatic Pressure Tester
Qualitest North America supplies testing and measurement equipment to laboratories, quality teams, and manufacturers, backed by responsive technical support and calibration service. The geosynthetic hydrostatic pressure tester range is built for reliable, standards-driven results, so you can source confidently from a single partner. Our team helps you match the right configuration to your samples, applicable standards, and throughput, then supports you through installation and beyond.
Request a Quote
Tell us the barrier materials you test, whether you need hydrostatic resistance, permeability coefficient, or both, and how many specimens you run per week. Contact the Qualitest team for pricing, configuration advice, and lead times.
