Scratch Resistance Tester - QualiHSA™ SRT
Scratch Resistance Tester QualiHSA™ SRT drags a hardened steel needle across coated surfaces under a fixed 10 N load to verify that protective coatings survive mechanical damage. Safety laboratories use the test on accessible parts of appliances and on coated printed boards where the coating serves as supplementary or reinforced insulation. A stepper drive controls needle speed, scratch length, and spacing, while a PLC and 7-inch touchscreen hold the recipe for repeat runs. Operators start a full sequence from a single button.
Needle geometry follows the published method: a 40 degree cone with a tip rounded and polished to R0.25 mm, held at 80 to 85 degrees against the specimen. Load stays at 10 N ± 0.5 N along the needle axis. Speed is adjustable between 0.1 mm/s and 30 mm/s with ±1% accuracy, which covers the 20 mm/s the standards call for. The stage indexes automatically through 90 degrees, so one setup delivers both vertical and horizontal scratch passes.
Scratch length, spacing, and repeat count are all set on screen, with a working range of at least 200 mm × 200 mm. Compliance engineers gain a controlled way to reproduce the scratch pattern before the electric strength check that follows. Manufacturers of appliances, power supplies, and IT equipment use the QualiHSA™ SRT to qualify conformal coatings and printed board finishes. Power options include 110 V 60 Hz and 220 V 50 Hz, so the machine drops into North American laboratories without a converter.